Approximate Sizes:
Leg Mold: (2 parts) 6 & 1/2" Thick X 12" Wide X 15" Tall
Bench End Mold: 2" Deep X 12" Wide X 16 & 1/4" Long
Bench Middle Seat Mold: 2" Deep X 12" Wide X 16 & 1/4" Long
Note: all measurements in US Inches

This set of 4 molds is made from durable
heavy duty .060 ABS

Finished Sectional Bench shown with Texas Longhorn coloring cast into the concrete
Our "Texas Longhorn" colored bench was cast for our Southwest location.

Bench Leg Mold
Bench Seat section mold Bench End Mold

(To make this bench you will need to purchase two one inch black or galvanized steel pipes in the lengths needed for your bench to support the seat sections and we recommend rebar to stabilize the legs in place for safety.) This set comes with instructions for casting and assembly and a length of one inch plastic pipe for making the grooves in the molded seat parts and casting the hole in the leg for the rebar.
Item # CON-001
$73.15

PLEASE SEE SHIPPING RATES AND TERMS. Shipping Rates & Info

ORDER SECURE USING

Make your own concrete benches for your lawn, garden, or flower garden! Using these molds you can make your own benches to fit any area. This set of molds allows you to make from a 2 foot long bench up to as long as desired. Since it is cast in sections and the main supports for the bench seat parts is two one inch steel pipes, (purchased separately) you can easily set this bench up where ever you want by yourself. The legs are designed so you can cast a hole down through the center of them to put rebar down into the ground for safety and support. The concrete can also be cast with wire in the seat sections so that you can wire the seat sections down if you have any concerns of someone walking off with your bench or for additional safety.

The molds can be cast with colored concrete or with white concrete mixed with coloring for a marble look or with other coloring methods mixing concrete colors into the molds as you want for unlimited affects. We colored some of the concrete mix and put it in the molds before adding the rest of the white concrete to get this "Texas Longhorn" coloring affect we wanted for our Southwest location shown in the picture above.

These molds can also be used to cast just the seat sections for placing them on other legs or supports such as concrete block, rock, or retainer wall areas where you don't need the leg casting mold as provided. This allows you to make stone seat sections for about any place you want them. The set comes with general instructions for mixing concrete and assembly. The legs requires at least two castings and you will need to cast at least two ends and as many middle sections as you will need for your total bench length. For safety, we don't recommend making a bench longer than 6 feet without adding more legs under the seat sections. The leg mold castings are designed to keep adding legs as needed to support your bench.

Click Here to see Products and Projects by Bruce Hauschildt

Shop with confidence on our site using PayPal® to pay!